WI-38 nuclear extract lysate (ab14911)

製品の概要

  • 製品名WI-38 nuclear extract lysate
    WI 38 ライゼート 製品一覧
  • 特記事項To ensure stability, we recommend aliquoting the extracts into single-use fractions and then storing them at -80ºC. The protein content has been determined by a Bradford-based assay.

製品の特性

  • 製品の状態Liquid
  • 保存方法Shipped on dry ice. Upon delivery aliquot and store at -80ºC. Avoid freeze / thaw cycles.
  • バッファーpH: 7.50
    Constituents: 0.48% HEPES, 2.34% Sodium chloride, 20% Glycerol, 0.003% EDTA, 0.042% Sodium fluoride, 0.0002% Sodium molybdate, 0.018% Sodium orthovanadate, 0.216% Beta glycerophosphate, 0.015% DTT
    Note: With Protease inhibitor
  • Concentration information loading...
  • 研究分野

    WI-38 nuclear extract lysate 画像

    • Each lot has been tested for AP-1 activation by using TransAM™ AP-1 Kits. The signal intensity for AP-1 activation in each lot is compared to the signal intensity obtained with extracts from unstimulated WI-38 VA13 cells. After the signals are blanked, the ratio of the signals from stimulated cells over unstimulated cells must be above 4 when using TransAM AP-1 c-Fos. This ratio may vary depending on the basal level of AP-1 activation in a given cell type.

    WI-38 nuclear extract lysate (ab14911) 使用論文

    ab14911 has not yet been referenced specifically in any publications.

    Product Wall

    There are currently no Questions for ab14911.
    Please use the link above to contact us or submit feedback about this product.

    Please note: All products are "FOR RESEARCH USE ONLY AND ARE NOT INTENDED FOR DIAGNOSTIC OR THERAPEUTIC USE"